Hardware & Shock Installation

Don't be greedy. Share!Share on FacebookShare on Google+Tweet about this on TwitterEmail this to someone

1.  Press axle (1) into the upper shock eyelet and lower eyelet.

2. Lightly grease the O-Rings. Slide the pin-cap (2) and o-rings (1) onto each side of the axle in the order shown.

3. Make sure everything fits securely with no gaps or side-to-side movement.

  1. Install both of the mounting bolts before tightening to spec. After they are both installed and everything is aligned, tighten to the bike manufacturer’s suggested specification.
  2. It is extremely important to check that no side-to-side play exists. Make sure the shock is fit securely.